Close



Results 1 to 2 of 2
  1. #1

    Bad Neptune 4 Max Layering Problem-- Help Please

    My Neptune 4 Max has been pretty nice in the 6 months I've had i (new). But there's a big problem, which is depicted in the attached photos of a film developing tank I drew up.. Photo 1 shows the approx position it was printed on the bed. Photo 2 shows the layer problem I'm having on the right half. The tank is about 12 inches wide and 10 inches tall, BTW. Photo 3 shows the problem as it appears on the back side of the tank. This tank is supposed to hold water, but it leaks on the right side. I am quite mechanically able to follow advise and instructions, but don't know what maladjustment to look for. As an aside, I notice the the bed rollers on the underside of the bed have no apparent way to get to the adjustments, aside from disassembling the machine quite a bit. But what is the problem I'm dealing with now? Thank you.
    Attached Images Attached Images
    • File Type: jpg 1.jpg (79.6 KB, 4 views)
    • File Type: jpg 2.jpg (86.5 KB, 4 views)
    • File Type: jpg 3.jpg (82.0 KB, 3 views)
    Last edited by galaxybeing; 01-27-2025 at 05:17 PM.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,202
    Add Roberts_Clif on Thingiverse

    Adjusting the Eccentic nuts

    ELEGOO NEPTUNE 4 PRO: How to adjust the eccentric wheel?


    https://www.youtube.com/watch?v=PdIiIy7f1Jk


    Hope this helps

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •