Hello,I tried to print theBenchy boat, but had the following outcome (see photos) . Any cluesfor improving?ThanksPrinter: QIDIX-PlusFilament: AmolenSilk Dual Color PLA 1.75mmRetraction Distance:1.5Retraction Speed: 30Layer Height: 0.2Line Width: 0.4Wall Line Count: 3Top Layers: 4Bottom Layers: 4Fill Gaps BetweenWalls: EverywhereInfill Density: 15%Infill Pattern:CubicZ Seam Position:Back RightZ Seam X: 270Z Seam Y: 200Print in Advance:yesBuild Plate: BrimBrim Width: 8Print Speed: 40Wall Speed: 20Top/Bottom Speed: 20Travel Speed: 100Min Layer Time; 10Print Temp: 210Build Plate Temp: 60Enable PrintCooling: yesCamber Loop: yesFan Speed: 100%Z Offset: 0Attachment 19931Attachment 19932Attachment 19933Attachment 19934Attachment 19935