Question-slicer ability

[harryroman]

Okay, so I generally use Bambu slicer (I’ve been meaning to switch probably to Prussia for a while bc Bambu lacks some setting just haven’t gotten around to it) ANYWHO in Bambu you can add primitives and they have a list of cube/cyl/torus/disk/sphere/cone but there’s certain shapes I’ve found myself adding once I’m in the slicer like a hexagon block or whatever but I need to go find that stl and import it then merge it then make it a negative etc. SO MY QUESTION: is there a way in Bambu or any slicer program to upload custom primitives to that list to use? Bc that would be so freaken helpful and save so much time

geometry dash lite

[Roberts_Clif]

Have you looked at Anycubic Slicer Next is an open-source slicing software developed based on Orcaslicer


Check it Out.
https://www.youtube.com/watch?v=ZEiKBNORUs0

https://www.youtube.com/watch?v=ZVBPsTCVvPE

https://www.youtube.com/watch?v=DDSQhC2lfAw