Close



Results 1 to 3 of 3
  1. #1

    Air compressor keeps running while 3D printing

    The air compressor constantly runs creating water drainage issues. We have an Industrial Air 80 gallon compressor (80 gallons @ 100 psi). The printer is: EOS P110 velocis (Demand: 5.9 CFM @ 150 psi.

  2. #2
    Super Moderator
    Join Date
    May 2020
    Posts
    688
    Quote Originally Posted by Klagola View Post
    The air compressor constantly runs creating water drainage issues. We have an Industrial Air 80 gallon compressor (80 gallons @ 100 psi). The printer is: EOS P110 velocis (Demand: 5.9 CFM @ 150 psi.
    Considering that you have posted about an air compressor in a forum dedicated to 3D printing I assume you will know where to get a discombobulater, if you get one with a double joint giggle pin you should then fit that on the compressor exhaust and run it at maximum revs.

    I'm sure this will solve the problem.

    An alternative would be to have someone 3D print a twin relay dinglebang.
    Last edited by Bikeracer2020; 10-31-2024 at 12:25 PM.

  3. #3
    get an auto drain valve

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •