Hello, I have a Creality Ender 3 V2 printer, and recently it has been doing something very odd when finishing a print. When done, it moves the extruder up and starts moving the bed forward (as usual). However, it seems to forget how long the bed is because I hear it crashing into the front endstop, and then it moves back to roughly the centre. I haven't made any changes in Cura or the settings as far as I'm aware, and it always homes perfectly.
If it moves the bed back, the same thing does not happen. I don't think it's a limit switch problem. The only adjustment I've made is the extrusion steps/mm, which shouldn't affect the Y axis? Is there an adjustment or calibration I should do, or is it an issue with the slicing/G-Code?
Hope that someone can help me!
Thanks in advance!