Results 1 to 5 of 5
Thread: Super Basic Question Creator Pro
-
07-26-2024, 03:15 PM #1
- Join Date
- Jul 2024
- Posts
- 4
Super Basic Question Creator Pro
Hi All,
Sorry to ask such a rookie question, but I cannot figure out how to lower the work platform/table after the alignment process on my Creator Pro. Currently, the platform is raised as far as it can go. I need some space under the nozzles so i can remove and clean them.
Thanks,
David
-
07-27-2024, 03:10 AM #2
- Join Date
- May 2020
- Posts
- 685
Most, if not all 3D printers have the option in the settings or filament menu to manually lower or raise the bed in the 'Z' axis by pressing a button on the touch screen.
Often in one to ten mm increments.Last edited by Bikeracer2020; 07-27-2024 at 06:03 AM.
-
07-27-2024, 06:37 AM #3
- Join Date
- Jul 2024
- Posts
- 4
Hi Bike,
Thank you so much for your reply !! I am wading through a 56-page manual that I have found online. I will try to find the section about the Z axis, and hopefully, Flashforge did theirs the same.
Much appreciated!
Thanks,
David
-
07-27-2024, 06:49 AM #4
- Join Date
- Jul 2024
- Posts
- 4
Hi Biker, All,
I jest read through the manual, and all I can find is an instruction to “lower the platform” before clearing the build plate, without a description of how to lower it. Hopefully, Biker’s suggestion will be the answer… !
Thanks,
David
-
07-27-2024, 03:37 PM #5
- Join Date
- Jul 2024
- Posts
- 4
Hi Biker, All,
That was it! To close this thread, the selection was Menu/General Settings/Jog. Once I got in there, I was able to move the carriage around as you described.
Thanks!
David
Kickstarter campaing LEGENDARY...
Yesterday, 12:54 AM in Free Self Promotion