Super Basic Question Creator Pro

[2002sheds]

Hi All,
Sorry to ask such a rookie question, but I cannot figure out how to lower the work platform/table after the alignment process on my Creator Pro. Currently, the platform is raised as far as it can go. I need some space under the nozzles so i can remove and clean them.


Thanks,
David

[Bikeracer2020]

Most, if not all 3D printers have the option in the settings or filament menu to manually lower or raise the bed in the 'Z' axis by pressing a button on the touch screen.
Often in one to ten mm increments.

[2002sheds]

Hi Bike,
Thank you so much for your reply !! I am wading through a 56-page manual that I have found online. I will try to find the section about the Z axis, and hopefully, Flashforge did theirs the same.
Much appreciated!

Thanks,
David

[2002sheds]

Hi Biker, All,
I jest read through the manual, and all I can find is an instruction to “lower the platform” before clearing the build plate, without a description of how to lower it. Hopefully, Biker’s suggestion will be the answer… !

Thanks,
David

[2002sheds]

Hi Biker, All,
That was it! To close this thread, the selection was Menu/General Settings/Jog. Once I got in there, I was able to move the carriage around as you described.


Thanks!
David