Close



Results 1 to 2 of 2
  1. #1

    Filament keeps breaking

    I have a creality ender 3 pro. I use creality pla+ filament. It breaks right at the Extruder. It breaks between the pulley and the gear on the stepper motor. it is the original setup from the factory. The only thing that i change was the hotend and that was a year ago. it looks like the filament is grind in half. It will work good for one print and then the next print it will break off. I check everything and it looks good. I even tighten the screw to make it tighter. thanks for the help i get.
    Last edited by edwardreed; 02-27-2024 at 07:37 PM.

  2. #2
    Super Moderator
    Join Date
    May 2020
    Posts
    668
    If your filament is ground in half, check the fteeth on the extruder are not clogged up needing to much pressure on the filament.
    Check for a clogged nozzle.
    Try a different spool of filament to check if the problem is in the filament which might need drying.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •