Results 1 to 2 of 2
-
11-02-2023, 07:29 PM #1
- Join Date
- Nov 2023
- Posts
- 1
Problems with Dice Printing Photon Mono
I am having problems with my Photon Mono that I am using to print dice masters. Almost all the sides seem to print fine except the bottom where the supports are. If anyone would have any ideas to help out, it would be massively appreciated. Attached are photos of some of the dice and the perimeters used in the Photon Studio program.
-
06-24-2024, 02:21 PM #2
- Join Date
- Jun 2024
- Posts
- 11
My first guess would be that the resin is pooling in the number and between the supports and not getting washed out thoroughly or curing before it drains away. My first reaction may be to position the die so that no numbers are flat and facing the build plate. Put one of the points of the die towards the build plate. Keep the supports at a minimum, and and don't make them too short.
What is the best material type for...
12-06-2024, 01:16 PM in General 3D Printing Discussion