I have a Ender 5 Plus and I believe there is an issue with my config file. Once I hook up all connections, and connect with occtoklipper the Z axis times out when I try to home it, and the X/Y gives: Unable to write tmc spi 'stepper_x' register GLOBALSCALEROnce the underlying issue is corrected, use the"FIRMWARE_RESTART" command to reset the firmware, reload theconfig, and restart the host software.Printer is shutdownI have 5160 Pro stepper drivers, Spyder 3 hotend, everything else is stock. [mcu]serial: /dev/serial/by-id/usb-Klipper_stm32h723xx_23003C001451313238353730-if00[heater_bed]sensor_type: EPCOS 100K B57560G104F[extruder]sensor_type: EPCOS 100K B57560G104F