Results 1 to 3 of 3
Thread: Creator Pro 2 Runs Wild
-
06-14-2023, 09:22 PM #1
- Join Date
- Jun 2023
- Posts
- 1
Creator Pro 2 Runs Wild
Can anyone explain what can be seen in the attached video? When I print the g-code for a single device, it prints fine - right or left. When I print the g-code for a duplicated device, my lefter extruder sits offline and the right extruder, after a couple of seconds, locks into a Y-Axis back-and-forth rampage. I tried power cycling the printer and recreating the g-code in Flashprint but to no avail. Do I need a new motherboard or is there a reset that I do not know about.https://www.youtube.com/shorts/tqgYrT-qGjc
-
06-15-2023, 01:59 AM #2
- Join Date
- May 2020
- Posts
- 688
Is your printer still under warranty ?
If so, send video and query to retailer for an explanation and hopefully a solution.
-
06-26-2023, 07:25 PM #3
- Join Date
- Jun 2023
- Posts
- 3
CP2 doesn't like the newest version of flashprint. I had to revert back to 5.3.4
Marlin Compiling
11-26-2024, 06:57 PM in General 3D Printing Discussion