3d printing noobie

[SadPandaa92]

Was looking for a part online Lock 'N Roll® Latch. Its a basic latch. Whilst I am decent enough at 3d modelling I wonder if any of you could answer some questions on this. 1. Where is the bets place to find parts like these? Tried google but a lot of sites seem to be about making figures etc. 2. Would ABS or even PLA be strong enough for a latch, even with a complete fill what are the limitations.

[Bikeracer2020]

Perhaps a picture of what you need would help, however there are dozens of different latches on Amazon.

I made a latch for my gate using ASA

[SadPandaa92]

So i don't have any good images to hand but this is the general idea. i have a ender 3 v2 max neo. it's big enough to print the size i need since the full length is not really required.