Results 1 to 2 of 2
-
05-01-2023, 07:48 PM #1
- Join Date
- Nov 2021
- Posts
- 1
Printing Problem - FlashForge 3D Creator Max
I just obtained an Creator Max and after getting it setup I did a test print of benchy and it was almost perfect so I decided to try another one and this one started off great. Meaning the bottom layers were near perfection but the layers after that were a complete disaster, at which point I halted the print. I am wondering what would cause this, I am including pictures for reference.
-
05-22-2023, 08:00 AM #2
- Join Date
- Nov 2022
- Posts
- 18
Did you ever get this fixed?
I see over 1100 reads, but no replies.
A little more info would help like what material, temp, and slicer used (and did you check and see if supports are required).
You can rule out a mechanical issue by printing something simple like a cube stretched in the z axis a little taller than where your print is messing up.
If that prints ok, then you can most likely rule out any mechanical issues, and look into slicer settings.
Marlin Compiling
11-26-2024, 06:57 PM in General 3D Printing Discussion