Results 1 to 3 of 3
Thread: Why doesn't this model work?
-
03-29-2023, 10:19 AM #1
- Join Date
- Mar 2023
- Posts
- 2
Why doesn't this model work?
Just made a little model vase in Onshape following a video tutorial. Looks good in Onshape and Cura but when you slice it the sides of the vase are only 1 pass thick, even though the model is much thicker than that. Is there some setting in Cura I need to change or did I make a mistake in Onshape? It should be 2.5mm thick.Thanks,Ben
-
03-29-2023, 11:14 AM #2
- Join Date
- May 2020
- Posts
- 689
Have you sliced it in 'vase' mode. That will literally only make a thin walled vase.
-
03-29-2023, 12:12 PM #3
- Join Date
- Mar 2023
- Posts
- 2
Think I worked it out. Seems to be a scaling issue. I made it too big in Onshape so when I scale it down in Cura it scales to only 1 pass-worth of thickness in the walls. Seems a bit rubbish though because now I've made the walls a bit thicker its suddenly jumped to like 20 passes-worth. That "vase" mode you mentioned "spiralize outer contour" makes it so its only doing 1 pass thickness again but that may be something to do with my noob CAD skills as before.
layers start moving
12-01-2024, 07:41 PM in Tips, Tricks and Tech Help