Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 03-17-2023, 12:37 PM #1
    munchl4xx
    munchl4xx is offline
    Student
    Join Date
    Mar 2023
    Posts
    1

    Malyan MA10 Mini Issues

    I just got a new Malyan MA10 Mini and it was fine printing last night when we got it but today when we try to print it goes off to the far right top corner and dumps the PLA with out even trying to print the actual job.We have the latest firmware for it and its only just happening today, the Cura setup is correct as it worked on a small boat design last night.Can anyone give me some hints tips and tricks to get this sorted out?
    Reply With Quote Reply With Quote
  2. 03-17-2023, 05:52 PM #2
    Bikeracer2020
    Bikeracer2020 is offline
    Super Moderator
    Join Date
    May 2020
    Posts
    508
    Sounds like your start and end G-Code could have been altered in your slicer settings.

    Contact the manufacturer and explain the problem and see if they will send you new slicer profile/settings.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules