Close



Results 1 to 2 of 2
  1. #1

    Malyan MA10 Mini Issues

    I just got a new Malyan MA10 Mini and it was fine printing last night when we got it but today when we try to print it goes off to the far right top corner and dumps the PLA with out even trying to print the actual job.We have the latest firmware for it and its only just happening today, the Cura setup is correct as it worked on a small boat design last night.Can anyone give me some hints tips and tricks to get this sorted out?

  2. #2
    Super Moderator
    Join Date
    May 2020
    Posts
    595
    Sounds like your start and end G-Code could have been altered in your slicer settings.

    Contact the manufacturer and explain the problem and see if they will send you new slicer profile/settings.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •