Results 1 to 4 of 4
Thread: a nagging print problem
Threaded View
-
02-14-2023, 12:05 PM #1
- Join Date
- Feb 2023
- Posts
- 2
a nagging print problem
Hello forum,
This is my first time posting on this site, I hope to get some guidance with some of my issues.
Most current issue is that I am trying to print a set of front and rear axles for a 1/25 scale pickup model. When I print the hole that runs through the axle is solid no matter the orientation that I try to print. Someone mentioned to me that I will need drain holes but I'm not sure that is correct. There are 4 holes that are in the leaf springs of one of the axles that come out just fine. The hole diameter is 2mm.
Anyone have some thoughts or things that I could try??
Thank you,
RickLast edited by limoman39; 02-14-2023 at 12:06 PM. Reason: puncuation
QIDI Slicer "Plater" is...
04-12-2024, 02:21 AM in QiDi 3D Printer Forum