First post so I apologize if this is in the wrong spot. I checked but didn't see a folder for Creality.

I've had this printer for a few years now and am at a 5% success rate in print jobs. I got the large print bed to make panels for cars and boats. With the large print bed, I assume it makes leveling much harder.

I did install a glass bed to help with leveling however, I am still having a hard time with it. All four corners are where they need to be however, the center is up a little too high.

I have heard from some videos online that this printer is not a good first printer. I am on my last leg with this printer as it is about to be a boat anchor. Any help is appreciated. Thanks everyone