Ran into some poor print issues last night.

Machine: Ender 5 Plus
Filament: Coex PLA-- JUST OPENED
Nozzle temp: 245° c
Bed temp: 65° c


Never had issues with Coex before. Usually prints with zero issue.
I was immaculate in my leveling and z offset tuning.
Filament would stutter, not forming consistent lines, would not adhere to the buildplate without lots of glue

I wondered if the over abundance of glue caused the spottiness?

Is there a way to adjust the pressure place on the filament in order for it to pass more consistently through the extruder?




19375BE0-FA90-4097-895E-0C439C91DAA4.jpg7A26994B-C105-490D-B865-5AECFB1B95C5.jpgE7E08F79-4FC3-495D-B9EB-48B4461D03A6.jpg