Close



Results 1 to 2 of 2
  1. #1

    Ender 3 V2 - Melted areas on the top of the first mm of layers - extreme jagged edges

    Dear community. Can please somebody give me a tip what to try to remediate melting on top of the bottom layers of my PLA prints - screenshots attached. It is especially visible on the bigger flat surfaces. I managed to significantly reduce jaggedness by online tips, but this melting is driving me crazy. I tried levelling the bed with regular A4 sheet of paper several times (I know it is probably not ideal) - the screenshot of the Cura test is attached (not ideal as well). The temperature of the bed is 55, hotend 205. Thanks in advance.
    Attached Files Attached Files

  2. #2
    Hello
    It looks like wet pla you can tell if you extrude some and you hear a crackling noise or see steam coming off. This can be fixed by drying it out there are plenty of good videos using a oven or a dehydrator like this one https://www.youtube.com/watch?v=CTrG7OAlsEA
    PlA should be kept dry to keep it good
    Hope this helps have a great day

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •