Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 01-05-2023, 11:06 AM #1
    Eisenwulf0083
    Eisenwulf0083 is offline
    Student
    Join Date
    Jan 2023
    Posts
    3

    reset to old firmware

    Hi, I tried updating my printer in hopes of using the SN04 sensor that came with that box.

    That didnt end well as the printer could not detect the Endstop when I try to home it after the firmware update.

    My last resort is to go back to the original firmware. I went to the MarlinFW site and the old firmware does not have an easy way to upload the firmware into the board.

    Any suggestions to get this printer back to the old firmware so I can use as opposed to having a large gift go to waste. This was given to me as a gift by a good friend and I would like to restore it and make sure the gift is not wasted. My thanks in advance.
    Reply With Quote Reply With Quote
  2. 01-16-2023, 02:24 PM #2
    3DPrinterMan1234
    3DPrinterMan1234 is offline
    Student
    Join Date
    Jan 2023
    Posts
    36
    Have you tries using youtube for help.
    Reply With Quote Reply With Quote
  3. 01-17-2023, 03:21 PM #3
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    We read here you have a SN04 Proximity sensor, It would help if you stated what 3D Printer you have.
    A few pictures of your 3D Printer could also be helpful if they show optional hardware.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules