Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 10-08-2022, 03:45 PM #1
    Jellytoes
    Jellytoes is offline
    Student
    Join Date
    Oct 2022
    Posts
    2

    CR Touch Bed Leveling System Help with Ender 3 Pro

    I have an Ender 3 pro and I just installed the CR touch bed leveling system. When I set the z offset and then start a print, it doesn't work, the tip is either too close or too far from the bed. It isn't working at all how it is supposed to. Is it the firmware? What am I missing? Any suggestions are greatly appreciated.
    Reply With Quote Reply With Quote
  2. 10-09-2022, 06:51 PM #2
    Jellytoes
    Jellytoes is offline
    Student
    Join Date
    Oct 2022
    Posts
    2
    Lots of views on this but no replies, just wondering if anyone out there has experience with this bed leveling system and could help.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules