Close



Results 1 to 1 of 1
  1. #1

    Unhappy Cube 5X Calibration

    Hello, how are you?Recently, I have started to use PETG as my new material, before of that I had been using ABS. But I stopped using ABS because of the cracking. I have been printing a lot of calibration cubes, and I tougth I was ready to print a bigger piece. This is the result, It has like small holes and empty lines in the walls. On the top, I dont know what happened. What do you recomend me to do? Thank you for reading!
    Last edited by Cartox; 09-26-2022 at 07:02 AM. Reason: Format

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •