Results 1 to 2 of 2
  1. #1

    Parts not sticking to bed

    Hi all,
    I’m printing using a standard Artillery X1, the problem I’m having is that either my parts warp or they don’t stick to the bed or sometimes both, I’ve adjusted the temps up and down, currently using 57 c for bed and printing at 215 c using PLA, I made three parts with no problem at these temps, then tried to print eight parts over night and ended up with a big mess, I’ve tried tabs etc but getting frustrated now,
    Any help greatly appreciated

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Washington State, USA
    Add Roberts_Clif on Thingiverse
    Clean your bed surface with 70% isopropyl alcohol or above,
    If this does not work then raise the bed temp to 100C for a couple minutes clean and try again.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts