Close



Page 2 of 2 FirstFirst 12
Results 11 to 19 of 19
  1. #11
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27

    Dancing crab

    dancing crab from my Twitch dancing animation series. Print is about 5 inches across.
    Attached Images Attached Images

  2. #12
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    Armadillo model I am currently building in blender3d. I'll probably print it out tomorrow.

    4.5 inches long. Cura slicer says about 3.5 hours.
    Attached Images Attached Images

  3. #13
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    First one I printed yesterday at 4 inches long felt too small. So reprinted today at 6 inches long and much happier with it.
    Attached Images Attached Images

  4. #14
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    Country chicken.
    Attached Images Attached Images

  5. #15
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    New model. My daughter loves hedgehogs. First print failed so trying again with a smaller print.

    Edit: Printed at 4.5" long. Pretty happy with the results from my poor model.
    Attached Images Attached Images
    Last edited by OG56; 09-04-2022 at 05:52 PM.

  6. #16
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    Halloween is around the corner and its my favorite holiday. Every year I make a couple of cnc patterns to celebrate. This year I am adding 3d prints into the mix.

    My first effort for this year is evil pumpkin first version. Its is currently printing. At 3 inches wide printer says about 11 hours at .2mm layer height and 20% infill.
    Attached Images Attached Images

  7. #17
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    Dang it. Print failure and filament stuck to the point I can't pull it out. So time to do some disassembly but that will be for another day.

    If I don't come back, you know what that means. I broke the machine.

  8. #18
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    I am still learning. There is something with my model and my machine settings that are not meshing. I have to either print hotter or slower based on my three failures.

    I printed at 3 inches = failure. Re-printed at 3 inches = failure. Tried at 2.5 inches = failure. Tried at 2 inches and successful print. All the failures were nozzle jams which happened at around the same point of the print. Got better at clearing them out. lol.

    I believe its due to my design with the current machine setting that is causing the failures.
    Attached Images Attached Images
    Last edited by OG56; 09-13-2022 at 06:56 PM.

  9. #19
    Student
    Join Date
    Jun 2022
    Location
    The great state of Texas
    Posts
    27
    Feed me Seymour!

    I will be trying to print sometime this week. Need to swap out nozzles. I believe that has been the reason for my last few failed prints.
    Attached Images Attached Images

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •