Close



Results 1 to 4 of 4

Threaded View

  1. #1
    Technician
    Join Date
    Feb 2017
    Posts
    79

    Weird curling problem when printing a thin item in 100% infil

    The print job is a 4.5mm thick plate (lid actually) that is 155x160mm (See attached stl). It will curl on the front right side of the print when printing infills of 50% or greater. Al though due to time constraints I only tested in 20% (my normal go to infill), 50% and 100% (What my goal infill for this job was)
    • The printer is a maker select 2 that I've had for many years.


    • The bed surface material was replaced a few months ago also but not because of this, just because it was years old.


    • I am using the same filament I've been using for 2 rolls from amazon (SUNLU).


    • I've had no other issues w/ this filament and reviews have been good


    • I print at 210/40C and always have w/o any issues

    printer config:
    • Maker Select 2


    • I have a duct w/ a cage fan that cools prints. Print cooling fan is running after layer 2


    • 210/40C


    • 1st layer 15mm/sec


    • all other layers 50mm/sec


    • .28mm layer height


    • 210/40C

    print info and tests I've run on same job
    • If I print the job at 50% infill it's better


    • If I print the job at 20% infill it does not curl


    • Tried to reduce printhead temp to 200, no change


    • Bed is level to .001" as confirmed w/ a feeler gauge


    • Bed is clear of any debris

    I don't think it's pertinent here but I have included a copy of the item I was printing.My
    Attached Files Attached Files

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •