Close



Results 1 to 2 of 2

Thread: Help needed

  1. #1

    Help needed

    Hi, i would love to print new buttons for an Alpine car stereo.
    But i'm pretty bad at 3D modeling.
    So i'm hoping that someone can give me a little push start.
    For CAD i have either Fusion360 or FreeCAD.
    And i hope (if that ever happens) to print those on a Photon S.
    Thanks for you future help
    Attached Images Attached Images

  2. #2
    Engineer-in-Training
    Join Date
    May 2020
    Posts
    230
    Suggest that you use something more precise than a plastic school rule to measure things.
    Then when you have more accurate measurements you will probably find your 3D skills improve somewhat.
    Then buy the printer you want to actually make the buttons.

    If it was me, I think I would just buy a new radio. Smaller learning curve, less time consuming, less expense and less frustration

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •