Close



Results 1 to 2 of 2
  1. #1

    First layer and bed levelling issues

    Hello!I am quite new to the 3d printing world as I recently got my ender 3 v2. To help with the bed levelling I installed jyersUi with 5x5 manual mesh leveling.The thing is, even though I have followed X tutorial videos on youtube on both how to tram/level the bed and how to do the mesh leveling I still can't get the first layer to stick unless I have a z-offset of about -0.2 mm or more.This is the case even if I make the paper almost stick to the plate when I set the mesh levelling. What could I be doing wrong?

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Sounds like you are doing every thing correctly.
    The Newest Marlin 2.0.9.2 has a function " Configuration > Advanced Settings > Probe Offsets > Z-Probe Wizard " To Set your Probe offset to get that perfect 1st layer.
    I have been manually using Probe offsets for 6 years now, only now with the new automated Z-Probe Wizard can I do this quickly and efficiently ...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •