Results 11 to 11 of 11
-
04-08-2022, 07:04 PM #11
I normally print this Frog
For a long time the only slicer I used was Cura 15.04.6.
After finding Prusaslicer I rarely use anything else
TreeFrog.jpg
Using Prusaslicer I can Add a modifier to eliminate a selected area or change the Layer Height an many other slicer traits.
I found a bit box an using a modifier I can delete half the bit holders as an added storage area
Bit Box1.jpg
Bit Box2.jpg
Best of all it is 100% free. An the quality of your prints will improve from the very first print.Last edited by Roberts_Clif; 04-08-2022 at 07:14 PM.
QIDI Slicer "Plater" is...
04-12-2024, 02:21 AM in QiDi 3D Printer Forum