Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 03-08-2022, 04:22 PM #1
    gbinco
    gbinco is offline
    Student
    Join Date
    Mar 2022
    Posts
    2

    Build plate hitting enclosure door when print is finished-Ender 3 v2

    Hi All,
    When my print is finished the plate is slid all the way forward and it hits my enclosure door. Is there any way to control this? I don't see anything in Cura or the Ender UI. I was thinking of updating firmware to Jyers, wondering if that would allow control over this function.

    Thanks!
    Reply With Quote Reply With Quote
  2. 03-08-2022, 06:47 PM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I have incorporated this into a simple End G-Code G1 X0 Y270 ; Move extruder to rear left, model to front for easy removal.
    Change the numbers so not hit your enclosure door.

    End_G-Code2.jpg
    Reply With Quote Reply With Quote
  3. 03-08-2022, 06:51 PM #3
    gbinco
    gbinco is offline
    Student
    Join Date
    Mar 2022
    Posts
    2
    Quote Originally Posted by Roberts_Clif View Post
    I have incorporated this into a simple End G-Code G1 X0 Y270 ; Move extruder to rear left, model to front for easy removal.
    Change the numbers so not hit your enclosure door.

    End_G-Code2.jpg
    Awesome, thank you so much!!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules