Close



Results 1 to 2 of 2
  1. #1

    bad layer when supports end

    ender3v2
    cura
    sainsmart tpu 95a
    sainsmart slicer settings
    every time the supports end, it makes a weird layer on my part. almost as if it is under extruding or my belts for my stepper motors are loose.
    Attached Images Attached Images
    Last edited by sqep; 02-12-2022 at 10:21 PM.

  2. #2
    is this a retraction setting?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •