Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 01-25-2022, 02:43 AM #1
    vladimir
    vladimir is offline
    Student
    Join Date
    Mar 2014
    Posts
    14

    Where to ask a question about Ender 3 firmware bug?

    I have ender 3 pro that has a non-native motherboard because the native one was damaged during a repair.
    It uses some version of merilo or merino firmware and the pause command has bugs. The table starts to cool when I select the pause command and then I cannot unpause the print.
    Which forum would be the best to ask this question in since I could not find this in the categories offered by this website?
    Thank you.
    Reply With Quote Reply With Quote
  2. 01-25-2022, 06:53 PM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    What controller is installed now.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules