Close



Results 1 to 2 of 2
  1. #1

    Elliptical cylinders

    Hello everyone! I shared a video to better explain the problem: https://www.dropbox.com/s/bb96ih5xsq...10108.mp4?dl=0
    By measuring a cylinder with the caliper I obtained these measurements:
    x axis = 4.70 mm
    y axis = 4.45 mm
    diagonal 1 = 5.2 mm
    diagonal 2 = 4.55 mm 0.5mm
    difference between the widest and the narrowest point is a lot!
    The curious thing is that if I print a cube it is precise!
    I tried to pull the pulleys and check that the eccentric nuts do not let the plate wobble, the extruder and also the z axis is guided by a support that I have printed, at its upper end. What can it be in your opinion?
    Thanks

    Slicer: Cura

  2. #2
    Great post I would like to thank you for the efforts you have made in writing this interesting and knowledgeable article drift huntwers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •