hey all,I am a novice when it comes to 3d printing and I have had a very hit or miss time printing. Here are the details of my set up and I will upload a video of my current issue:Ender 5 Pro w/ Silent Mother Board (https://www.amazon.ca/gp/product/B081SPJ2VX)Creality Ender 3 Glass Bed (https://www.amazon.ca/gp/product/B07RVCJS69)OVERTURE PLA Filament 1.75mm (https://www.amazon.ca/gp/product/B07PGY2JP1)PLA has been put into dry boxes with the humidity at around 17-20%I originally was using the magnetic bed that came with the printer and my prints would sometimes stick and most times not, I used glue and it just turned into a mess and so I upgraded to the glass bed reading that was better and gave smoother finishes on the base. The glass bed had the same issues so I added blue tape. The tape works great, a little too great because I could never get my prints off unless I use a spatula and a rubber mallet, even after leaving it to cool overnight, I was wasted so much tape. I have being tried to get it to print to the glass bed with nothing else, I don't want to use glue, or hair spray, or tape or any other strange concoction. I really don't think it makes sense that something like this was built to fail unless we use random hacks to get it to stick. I have watched so many videos and read so many articles, ranging from bed temp, nozzle temp, leveling, z-stop changes, Cura setting changes, cleaning the bed, printing support structures to help print (which makes no sense because if I can't print how am I supposed to print something to help me print) and I am just at my end with this thing. I am hoping someone can just watch the video and give me a more clear answer of what the heck is going on. As of right now some corners of my initial layer starts curling up and then the nozzle will either hit it and cause it to move and therefore turn into a stringy failure, or the corners keep curling up and my print is warped in all corners. Someone please help.https://photos.app.goo.gl/Q7jmAvET1JUS1Anq5