Close



Results 1 to 4 of 4

Thread: Octolapse error

  1. #1

    Octolapse error

    I have an Ender 3 v2 running OctoPrint on a Raspberry Pi 4B. The camera is connected via USB and works fine for monitoring prints via OctoEverywhere. But, when I try and send a print from Cura (4.11.0) with the Octolapse plugin enabled, for timelapse, I get the following error.Where are these values set that I seem to be missing?
    Attached Images Attached Images

  2. #2

  3. #3
    I had a problem once. I could not install the Xmind program to work in English. And it seemed that I was not the only one who had this problem and my team and I could not solve it for about a week. Until on one of the forums while searching for information to solve the problem I came across this site: https://www.xmind.net/download/ . By clicking on the link you will be able to solve the problem with which I and my team faced.

  4. #4
    I’m hoping you would share your thoughts on how important it is to reply to comments on your blog.
    ole777 mobile

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •