Show your MODS

[RobH2]

Really nice looking. Clean and excellent wire/cable management.

[BLKKROW]

Does that drag chain run into the aluminum extrusion at the top?

[mattbenimble]

Does that drag chain run into the aluminum extrusion at the top?

It just touches if i run it to the default Marlin settings from Makerfarm. I dont forsee needing to go that high anytime soon, so it works well for me

[66Mhz]

Here is my pegasus. i have had it for a few weeks and been very happy with what it can print. Everything in Orange PLA (hatchbox pla) is printed on it and have had minimal failed prints.

Nice setup! What enclosure are you using for your RAMPS board and power supply?

[adamfilip]

easy way to reduce 80% of the warping with ABS.. Switch to PETG, it doesnt shrink and warps much less then ABS,
I use PETG and I add a few mouse ears to parts that will likely warp and it fixes the issue.
plus ABS is toxic so avoid using it. PETG isnt toxic and its very strong
I dont use an enclosure yet

[usarmyaircav]

I am having such a hard time getting petg figured out. for the right extrusion/ temp settings etc. I don't mind the strings but small prints I am wondering if I need a print fan because it is not working, and the first layer seems to have issues sticking, which is really odd as I have a sheet of PEI, However my first print with PETG, I printed at ABS temps, and ran into some issue, and had to pry the print off, which might have messed up the pei, and I am wondering if it warped my glass-cork-wood bed.

[adamfilip]

for PETG I print 245 nozzle with Fan blowing 100%, 80 bed with PEI, with great results

[clough42]

I have had great success printing PETG at 240C/80C with Garnier Fructis Extreme Hold #5 on glass.

[plackslayer]

PETG works great for me at 240/80 and elmers kid glustick on my glass.

[PyramidDave]

I am just printing PETG at 230 with no heatbed on painters tape & elmer's gluestick on Mirror from Lowes.