Close



Results 1 to 4 of 4
  1. #1

    How to connect to E5 + S6 V 2.0

    Hello.I would need advice on how to connect the power supply to the S6 V 2.0 board so that I can install it in place of the original Ender 5 plus board.Thank you in advance for your help.
    Attached Images Attached Images

  2. #2
    Staff Engineer
    Join Date
    Jul 2016
    Location
    South Florida, USA
    Posts
    1,150
    Add AutoWiz on Facebook
    The pins are labeled on the backside of the mainboard. You will also connect power and ground from the power supply to the hot bed input. The S6 has this extra header so you can run a separate power supply for the bed if you like..


  3. #3
    Hi.
    This is actually described on the back wall of the board. PWR - I plug in the power supply. What is HBIN for? BED - should I engage the bed? PC8, PC7, PC6 - to which should I connect the hotend heater ?. I'm just learning it, so I'm asking very basic things.

  4. #4
    Liteblue is the online portal for all United States Postal Service employees. The portal was created to grant exclusive access ofr USPS staff to the company’s private online intranet network. Using this service, all USPS employees can view a range of employment-related information. https://liteblue.red

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •