Close



Results 1 to 5 of 5

Threaded View

  1. #1

    What’s the problem with this print?

    Hi,I am trying to identify the problem. The print looks quite good, except the occasional horizontal lines. Is that due to over extrusion? I am using simplify3D slicer, printed on creakily CR-10.Empty shell, the wall line count (outline shells) is 1.Any input would be greatly appreciated!
    Attached Images Attached Images
    Last edited by RedAlert; 07-20-2021 at 09:14 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •