Close



Results 1 to 3 of 3

Hybrid View

  1. #1

    Exclamation H2 BigtreeTech stops while printing

    If got a new H2 Extruder and installed it on my Ender 3 with an SKR mini e3 DIPP(2208). If done E-stepps, Home offset, set the motor current, PID tune, changed the settings in cura like retraction and many more. But the print will always fail. It starts normally and then after the skirt it fails(The Extruder just stops. The Motor has no torqued, so you can move the extruder Wheel with your hand.) Sometimes the Printer prints like 10min and fail. But the Print will always fail. I have no idea. If somebody can help me out would be great. Thanks a lot.Marian

  2. #2
    Quote Originally Posted by marian375 View Post
    If got a new H2 Extruder and installed it on my Ender 3 with an SKR mini e3 DIPP(2208). If done E-stepps, Home offset, set the motor current, PID tune, changed the settings in cura like retraction and many more. But the print will always fail. It starts normally and then after the skirt it fails(The Extruder just stops. The Motor has no torqued, so you can move the extruder Wheel with your hand.) Sometimes the Printer prints like 10min and fail. But the Print will always fail. I have no idea. If somebody can help me out would be great. Thanks a lot.Marian
    Please send some photos, it will help.

  3. #3

    Videos

    Quote Originally Posted by 3ba printing View Post
    Please send some photos, it will help.
    Sry dude
    https://youtu.be/5rDKJtc-pqo
    https://youtu.be/F-v5r5tJ6ZU

    i tried to show most off the problems.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •