Results 1 to 10 of 11
Thread: Warping, Ultimaker 2
Threaded View
-
07-09-2021, 10:57 AM #1
- Join Date
- Jul 2021
- Posts
- 3
Warping, Ultimaker 2
I've been having warping issues lately on my Ultimaker 2. Not sure what else I can do to stop them.
Setup:
* Ultimaker 2 with olsen block
* Plexiglass door to keep consistent temps
* Tape over top to keep enclosure a toasty 125F / 51C
* GeckoTek EZ-Stik on my glass buildplate
* 0.4mm hot end
* Bed at 80C
* Good quality + fresh ABS filament
*STILL* getting horrible warping. Any ideas?
photo_2021-07-09_10-56-10.jpg
photo_2021-07-09_10-56-08.jpg
photo_2021-07-09_10-56-14.jpg
I've been doing this long enough, you would think I would be past these kinds of issues lol. (bed is 84C in that last photo because I just cranked it up to 85C from 80C)Last edited by kallisti5; 07-09-2021 at 11:03 AM.
Print not sticking to base plate?
04-22-2024, 01:26 PM in General 3D Printing Discussion