Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 11

Threaded View

  1. 07-09-2021, 10:57 AM #1
    kallisti5
    kallisti5 is offline
    Student
    Join Date
    Jul 2021
    Posts
    3

    Warping, Ultimaker 2

    I've been having warping issues lately on my Ultimaker 2. Not sure what else I can do to stop them.

    Setup:
    * Ultimaker 2 with olsen block
    * Plexiglass door to keep consistent temps
    * Tape over top to keep enclosure a toasty 125F / 51C
    * GeckoTek EZ-Stik on my glass buildplate
    * 0.4mm hot end
    * Bed at 80C
    * Good quality + fresh ABS filament

    *STILL* getting horrible warping. Any ideas?

    photo_2021-07-09_10-56-10.jpg

    photo_2021-07-09_10-56-08.jpg

    photo_2021-07-09_10-56-14.jpg

    I've been doing this long enough, you would think I would be past these kinds of issues lol. (bed is 84C in that last photo because I just cranked it up to 85C from 80C)
    Last edited by kallisti5; 07-09-2021 at 11:03 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules