Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Qidi responded very quickly to my enquiry and sent an update kit for the carriage. I dont know why the carriage has an effect on the z axis starting point but I fitted the new kit and it has worked faultlessly since and I have done a lot of printing. Not only thay they followed up the bits with an email to check all was ok. The only issue I had was I could not get some of the screws out (very small heads) so had to change a bit more stuff BUT it was in the kit. Lots of extra bits in the kit so was not worried.

  2. #12
    Hi, I am new in the forum and I just started the printer today. Everything fine except the Wifi or Lan connection I fail to get working. Same as your post. Any idea ?

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts