Close



Results 1 to 10 of 49

Threaded View

  1. #1

    And Back to getting my Two Trees Sapphire Plus working

    In other threads, I've described my adventures getting this printer working. As of February, Two Trees had shipped me a new thermistor to replace the one in the unit that they determined was defective. And so, we continue.I've managed to take apart most of the extruder in order to get at the thermistor. I'm including some pictures. I've removed a larger cylinder that, due to the heavy wires, I'm assuming is some sort of heating element, that was locked in with a set screw. The thermistor is a much thinner cylinder next to it. I can't figure out how to remove it as it is jammed into its hole pretty tight. No set screw. I've tried pushing it through from the opposite end, but it won't move, and before I stick the thing in a vice and start putting some heavy duty pressure on it, I thought I'd check here first. Should this thing be the hard to get out? As always, thanks for any guidance. Ron
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •