Close



Results 1 to 1 of 1
  1. #1

    Blobs - Not printing correct

    Hello

    Wasn't sure which forum this should go in. I purchased a Creality CR 6 SE about two weeks ago. The printer has been working excellent and I have done about a dozen prints using 3 different PLA filaments. Yesterday I switched over to a "Marble: effect filament with a heat range of 190-220c bed temp of 0-50c. I set my file to print at 220, then 210 and finally 200. I'm getting blobs of filament and an over all crappy base (I stopped printing after 10 minutes). I'm assuming the blobs are because the temp is too high? The other pieces I printed on the other filaments were at 200 and looked great. Base layer was very smooth. Attached are a few photos before I canceled printing.The bed is level, I confirmed this after cancelling the print with the marble filament and switching back to the other filament I had success with. Starting printing again it everything is fineThanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •