Close



Results 1 to 3 of 3
  1. #1

    Stringing Problem Ender 3 Pro

    Hi everyone, I've been printing the same stl file for my business over all my ender 3 pros. Recently I have been getting this stringing problem shown in photos below. I've tried everything I can think of from extrusion problems to the point where i have just replaced the whole extruder stepper motor however still the same problem. The outside is perfect, the layers are not squished and it is not over extruding. I just cant figure it out, if anyone has any suggestions at all send them my way please!

  2. #2
    Technician xayoz's Avatar
    Join Date
    Jan 2020
    Posts
    92
    try changing retraction settings

  3. #3
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I would also set the starting position to random.

    Random.jpg

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •