Close



Results 1 to 3 of 3

Thread: layer help

  1. #1

    layer help

    on my prints i have been noticing a lip near the bottom of my prints not sure what is causing this
    Attached Images Attached Images

  2. #2
    Technologist
    Join Date
    Apr 2021
    Posts
    128
    Does it occur at the same height as the "floor" on the other side of the wall?

    What slicer?

  3. #3
    yes it occurs at the same height i use cura

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •