Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3

Thread: layer help

  1. 05-08-2021, 03:10 PM #1
    crazymonke42
    crazymonke42 is offline
    Student
    Join Date
    Aug 2020
    Posts
    29

    layer help

    on my prints i have been noticing a lip near the bottom of my prints not sure what is causing this
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 05-08-2021, 10:18 PM #2
    Martin_au
    Martin_au is offline
    Technologist
    Join Date
    Apr 2021
    Posts
    186
    Does it occur at the same height as the "floor" on the other side of the wall?

    What slicer?
    Reply With Quote Reply With Quote
  3. 05-10-2021, 08:43 PM #3
    crazymonke42
    crazymonke42 is offline
    Student
    Join Date
    Aug 2020
    Posts
    29
    yes it occurs at the same height i use cura
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules