I have been using Cura and Fusion 360 to slice my code.Cura seems to have about every option I could imaging (I am using Creality Ender-5). But I wonder if other slicers give you more control over the final GCODE. For example 3 top and bottom layers suffice for a lot of prints but there are areas that need strengthening, ability to drill later etc, and in those areas perhaps increasing to more layers makes sense. Also having a way to view areas of GCODE and see them represented on the slicer graphic would be handy for trouble areas. And of course there is the general issue of generating the cleanest-or fastest- slice. I was wondering if other slicers may produce better results and control. I had Simplify3d in mind for example.Anyone have some real world comparisons?ThanksFritz