Relative noob with E3Pro that was working until today when print about 1/4 to 1/3 completed became unstuck with resulting giant bird-nest. Then I levelled the bed as usual, print began, then nozzle just went into bed. Sliced new stl in Cura with standard Cura profile and Chep's good profile also, then did complete levelling routine with Zstop adjustment, etc. Now when I auto home the carriage will raise a bit, move slightly to the right, raise about 5-6 mm and stop without going back down to the normal position ready for levelling. No BLTouch, etc installed. Patience and knowledge(!) exhausted! Any ideas short of trashing it? Have been considering replacing with a new 4.2.7 silent board and possible firm-ware up-date--is it time for that? Sort of a wuss way out but for this I'm no t very macho. Appreciate any/all help!Enable GingerCannot connect to Ginger Check your internet connection
or reload the browserDisable in this text fieldRephraseRephrase current sentenceEdit in Ginger×