Close



Page 33 of 33 FirstFirst ... 23313233
Results 321 to 322 of 322
  1. #321
    Hi, good to see this Creator section on the forum.
    I recently own the Creator 3 and notice it looses WIFI connection after a while during a print job and not coming back on. Even after waking up the display the WIFI does not come back while it is printing a job. Not sure if is related to the display going into sleep mode / protection mode or something else.
    Does anyone experience this as well and or found a solution for it? Because of this i loose my camera stream as well as progress indication in Flashprint while printing.

    Thanks for your feedback.
    Dave
    Last edited by davaze; 01-04-2021 at 10:25 AM.

  2. #322

    That
    sounds really frustrating! Have you tried adjusting the height of the second nozzle? If it's too close to the build platform, it can cause the model to be knocked off. If the height is adjusted properly, then the second nozzle should not affect the model in any way. If you decide to remove the second nozzle, make sure to store it in a safe place for when you want to use it in the future.

Page 33 of 33 FirstFirst ... 23313233

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •